|
|
|
|
|
|
|
|
|
|
|
|
|
|
 |
 |
 |
|
02-27-2009, 08:24 PM
|
#1 (permalink) |
|
Junior Member
Join Date: May 2008
Posts: 11
|
i've decided to beef the kfx up for this coming year i'm putting in a 13:1 piston kx cams pIII most likely dasa exhaust and if fuel atv is willing to gimmie any deal if i buy the big three then his intake
my question is will the oe clutch be strong enough for the increased hp. ( i just burned it out in under a year ) i don't have the money to buy the whole hinsen clutch kit for 1000. Any alternatives? can i use just hinsen plates and not the basket springs. ect.. any thoughts would be helpful |
|
|
| Sponsored Links | |||
Advertisement | |||
|
03-02-2009, 08:22 PM
|
#2 (permalink) |
|
Senior Member
Join Date: Nov 2007
Posts: 148
|
I like stock fibers and steels over anything. Hinson stuff is great but its over priced i think its 200$ for clutch and fibers. Those mods stock clutches are no problem. If i was you there a smaller fiber and a ring on the inside of all the clutches. Replace the mini fiber and ring with a full fiber. And throw some washers on your clutch springs to stiffen it up the cheap way. This should get u trough the year with no problems
|
|
|
|
| Sponsored Links | |
Advertisement | |
 |
| Thread Tools | Search this Thread |
|
|
