Kawasaki KFX450 Forum - KFX450Central banner

1 - 3 of 3 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter #1
Make offers, may be willing to trade or trade + cash on your end depending on what you've got. Lowballers will be ignored, I'll be losing enough money on this as is. Don't be ignorant.

Low hours, never crashed or flipped, garage kept when not in use, very well maintained, and only the best chemicals have been used since purchase (Motorex ATV Quad Racing fully synthetic oil, Motul brake fluid, Motorex chain clean and fully synthetic chain lube, PJ1 air filter oil, etc.)

MX/SX ready and even at 50 inches, it goes through trails just fine and only needs a different tire setup to compete in woods races. This quad gets tons of attention wherever I go with it and tons of compliments and will make someone very happy, I just want to try my luck with something else.

Will also come with another full set of white plastics w/ black removable fenders, stock a-arms, axle, headlights, and other odds and ends pieces that have been upgraded.

Over $13,000 invested between the bike and after-market parts. And that's not including the time and labor costs put into installing the parts. Someone can make a good bit of money back by selling leftover parts if they wanted to as well.

Mods list:
-Houser Racing reg. travel +2-1/4" gloss black a-arms
-Lonestar Racing Axcalibar adjustable 1.5"-4.5" axle
-Streamline +2" steel braided front brake lines
-Galfer rear steel braided brake lines
-Pro Armor black Fat Peg nerf bars
-Pro Armor black Bullhorn front bumper
-Pro Armor Pro Race rear grab bar
-Pro Armor full chassis skid plate
-Pro Armor swingarm skid plate
-Fasst Co. 15 degree Woods SS Flexx bars w/ damper crossbars
-BRP Flexx bar handguard mounts
-Cycra Probend racer pack
-Allrite anti-vibe gel grips
-Maxxis Razr Cross 19x6x10 front tires
-Maxxis Razr iMX 18x10x9 rear tires
-Motoworks FMI
-Motoworks SR4 Carbon full exhaust
-Gunnar tether killswitch
-Maier one piece rear plastics
-Lonestar Racing parking brake block off plate
-OEM white hood
-Turner gas cap vent tube

I’m a member of a ton of forums and don’t remember to check all of them every day, so if you may be interested, please e-mail me at [email protected]













Thanks for looking!
-Ben
 

·
Registered
Joined
·
40 Posts
Discussion Starter #2
PRICE DROPPED TO $7500 W/O FLEXX BARS!!!

THATS NEARLY HALF OF WHAT IT WOULD COST TO BUY THE QUAD AND ALL THE PARTS & LABOR, ETC.
 

·
Registered
Joined
·
40 Posts
Discussion Starter #3
Come on boys and girls....someone buy this thing!

I finally had enough of my boss's bullwooter this morning and told him to shove it up his scrawny ass. I was hoping to have a job before leaving that wooter hole, but I'm not going to be treated like a dumb ass.

So, to make a long story short, I need this thing gone before I run out of money.

Tell anybody you guys know who might be interested in buying a quad about this thing.


$6,500 for everything! That's less than most people have bought stockers for!!!!

Thanks guys!
 
1 - 3 of 3 Posts
Top