FuelATV Intake Install

First make sure you read the instructions that is provided by FuelATV. After you have read through the instructions a few times, you should be ready for the install.

Verify you have all the parts you need for the install


Lift up the quad so the rear suspension is at full droop


Looking at the shock at full droop from underneath


You can get to one of the hose clamps here


Looking down on the stock intake. You can see the two hose clamps that hold on the larger intake tube and the air temperature sensor mounted on the old air box



Crank case vent tube connection to the air box


The stock larger intake tube. Fuel is right, this thing is VERY RESTRICTIVE


Mounting the billet adapter into the new intake tube. It is a tight fit, but if you put a couple fingers on the inside of the tube and push the intake tube over the billet adapter, it will slide together without too much problem


After removing the air box completely (4 top bolts + 10 lower sub frame bolts), you can install the new intake tube


Continue to Part 2