Kawasaki KFX450 Forum - KFX450Central banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I have installed a Gunnar Killer on my KFX450R. After installing I rode it for about a day in the woods without issue. The next day I was scheduled to race a hare scramble event. When I went to pull the bike off the trailer it took forever to get it started. Kept quitting... About half way through practice it died completely and would not re-fire.

Took to Kawasaki and they said the kill switch fried the fuel pump relay. They are bypassing the kill switch and installing a new relay.

I have re-traced my steps and canot figure out what I may have connected wrong. I spliced the Gunnar (NC) into the yellow wire with red stripe that is coming down form the OEM kill switch and connected the ground to that steering stem mounting bracket.

Thanks for reading and any help would be appreciated.

Boomer
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top