[topdollr]

anyone else have any problem trying to remove the stock tool box? The exhaust side bolts came out fine but the other side wouldn't. I had to drill them out they just spun around. I was installing the PcIII today. That really makes a difference in response after taking the lid off and pea shooter out.

 

[PCMamerica]

Mine didnt come out either so I mounted the PC3 on the front leftr of my gas tank below the handle bars. Looks good and everyone questions what it is.

 

[kx515]

QUOTE (PCMamerica @ Apr 23 2007, 08:00 AM) index.php?act=findpost&pid=1432

Mine didnt come out either so I mounted the PC3 on the front leftr of my gas tank below the handle bars. Looks good and everyone questions what it is.

3 out of 3 so far. I had the same problem.

 

[topdollr]

One of the bolts that I drilled the top off I was able to get the stud out but the other is still in there just haven t had time to take it out.

I went to put a new bolt in but it wont tighten down just spins, do you guys think this should be covered under warranty?

when I take mine in for the frist service I am going to ask.

 

[Guest]

QUOTE (topdollr @ May 4 2007, 12:06 AM) index.php?act=findpost&pid=1699

One of the bolts that I drilled the top off I was able to get the stud out but the other is still in there just haven t had time to take it out.

I went to put a new bolt in but it wont tighten down just spins, do you guys think this should be covered under warranty?

when I take mine in for the frist service I am going to ask.

I would think you would get that covered un warrenty no problem.