[nwdunerider]

today I had a slow motion rollover almost standing still . afterward my bike will not start It has spark but the plug is DRY the rollover sensor was off its mount so I zip tied it on but the bike just cranks over and over Any Ideas

 

[topdollr]

you need to silicone the piece of the switch that moves

 

[azkfx]

cycle the power switch on and off a few times to reset the rollover sensor, hope that helps.

 

[Djr-xc-racer29]

Have you gotta break it open to do that???

 

[topdollr]

QUOTE (Djr-xc-racer29 @ Jul 22 2008, 04:54 PM) index.php?act=findpost&pid=10478

Have you gotta break it open to do that???

yup

 

[nwdunerider]

so do you think that the sensor is stuck open

 

[topdollr]

might be, open her up and let us know what you find

 

[nwdunerider]

QUOTE (azkfx @ Jul 22 2008, 11:15 AM) index.php?act=findpost&pid=10472

cycle the power switch on and off a few times to reset the rollover sensor, hope that helps.

I Have turned it on and off 30 times no luck

maby I could just tap it with a wrench !!!!

QUOTE (topdollr @ Jul 22 2008, 07:44 PM) index.php?act=findpost&pid=10493

might be, open her up and let us know what you find

maby I should tap it with a wrench!!!!!

 

[slideways72]

You dont have to break it open. On the inside where the prongs hang down there is a release tab. Push that release tab out and the guts will slide right out.

 

[nwdunerider]

Today I shook the rollover sensor and it made no differance I could feal the weighted pendulem move
So I took it the the dealer I know it gets spark seams like it gets no Fuel will let ya know what they find. The last time I had it in it took 9 weeks They sent it home 3 times supposedly FIXED at a cost of 500.00 finnaly it turned out to be the fuel pump warranty work so here we go again

 

[nwdunerider]

picked up my bike today turns out that the throttle cable came undone from the throttle body they connected it and adjusted it and it works fine !!!!!!!!