Kawasaki KFX450 Forum - KFX450Central banner

1 - 5 of 5 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
I was wondering if anybody figured it out. I put on a PCIII and a ProCircut T-4 slip on and now it doesnt start in gear. I went to my local dealer and the brand new kfx450 on the floor will start in all gears? just wondering if anybody as figured out a fix for this problem?
 

·
Registered
Joined
·
18 Posts
Discussion Starter #3
yes with the clutch... i checked all my wires from the PCIII and all under the hood. all check out to the diagram from kawi
 

·
Registered
Joined
·
271 Posts
Go over the wiring you worked on, more than likely something is loose. It happened to me on my YFZ and that's all it was.
 

·
Registered
Joined
·
11 Posts
It's sounds like it's the switch on the clutch lever. Make sure the wire that goes to the clutch lever is plugged in.
 
1 - 5 of 5 Posts
Top