Kawasaki KFX450 Forum - KFX450Central banner
1 - 1 of 1 Posts

·
Registered
Joined
·
82 Posts
QUOTE (nogard @ Mar 16 2008, 09:02 PM) index.php?act=findpost&pid=7355
I am doing the same thing. The angle to hit the ball joint doesn't seem sufficient or enough clearance. If I am able to get the ball joint out will they still be usable or do I buy a new set?
put the nut on the end of it and hit the nut it will keep the thread safe then take the nut off once it comes lose good luck
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top